Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

How to Register on LPF | LPF Donations

The REAL Kryton GB round #3. Taking payments now.






Icecruncher...I can't help myself from staring at your avatar...I want what you have...

And hopefully soon I will have it!!!
 
Yeah you can still get in on the beasts and the grooves. I am still negotiating the beasts so I honestly haven't got an accurate time frame. I ABSOLUTELY HATE to leave folks in limbo like this and if we can't make some headway soon, I'm going to start refunding money...

I will state this. REGARDLESS THESE BEASTS WILL BE REALIZED! I will not abandon them.
 
run into one more issue. Apparently, I need to get a flow through system for my vibratory polisher. The aluminum dust that is building up inside the polisher is making it so that the media isn't getting polished. it's creating a buffer so that it's not polishing. The polisher I've got hasn't got a sealed bowl so I'm going to have to make it sealed with silicone or buy a new bowl (in the vascinity of $190) and then buy a pump and some tubes as well as some chemicals to pull the dust off the media and dump it in a bucket as it polishes. ($60)
 
Looks like I might have this solved. I have done some modifications to the polisher that may work in allowing me to use this as a flow through system. I will test it tomorrow and report.

I still need to buy the chemical to flush the gunk out while it's polishing, but the mod was relatively inexpensive.
 
Extrion was nice enough to sand blast the few that needed them. Here they are

05ba3fda.jpg

9b3e47f3.jpg

953528d5.jpg
 
Thanks Kenom :paypal: Please advise if I should put it in the spreadsheet also. I didn't see any beasts listed (at least named) in the SS and wasn't positive what each of the columns are intended for (i.e. not 100% postive if Col F is intended for the Beasts).

:beer:
 
it was intended for the beast but that's why I specified in the payments that it be in a specific format cause folks keep messing with the spreadsheet. I have the specifics in the payment so I can always go back and refer to that.. so updating the spreadsheet isn't necessary.
 
I have no idea if this has been posted, 43 pages... haha

But, do you have an idea of when these will be available? and when would I have to have my payment in to meet the deadline, I want one, but would like to wait a week or two before I paid if that is okay.
 
it is my hope to have these finished by the end of next month. I have the anodize setup all ready to go, and as soon as I get a good finish on all these barrels, I will start anodizing. Now let me state, just because the anodizing is done, does NOT mean these will ship. They will then get sent to a Laser engraver to have the logo laser engraved onto the barrels.

DSC00509.jpg

DSC00375.jpg


You have plenty of time to get on board.
 
Last edited:
Oh GAWD! I forgot ALL about the laser engraving of the logo... DROOOOOOOL!

I've got a source for some blue rubber cord to put in the grooves. It's going to look just absolutely sick!

(chortle)
 
You must log in or register to reply here.


Back
Top