Paulostool
Active member
- Joined
- May 24, 2024
- Messages
- 54
- Points
- 33
Got some mech adapters from jnrpop but I needed a battery.
I wanted something really short, so decided to start with 18350 host.
To match the finish of the heatsinks I choose a Stainless Steel Convoy S7, got some connectors to fit in and ground the head until it got around 7cm total length.
Next steps are creating my custom adapters and fitting some yellow DPSS on them.
Adding some photos comparing to a 21700 cell, to a short and a normal S2.
The goal was to make it not much longer than a normal host.
I wanted something really short, so decided to start with 18350 host.
To match the finish of the heatsinks I choose a Stainless Steel Convoy S7, got some connectors to fit in and ground the head until it got around 7cm total length.
Next steps are creating my custom adapters and fitting some yellow DPSS on them.
Adding some photos comparing to a 21700 cell, to a short and a normal S2.
The goal was to make it not much longer than a normal host.
