Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

How to Register on LPF | LPF Donations

Dead Blu Laser

Joined
Dec 17, 2008
Messages
2
Points
0
I bought a laser awhile back on the forum. Ran great, but I fried it. Anywho, its a 130mW MXDL using 175ma flex. I'd like to fix it, but I don't have the know how, or time. If you can message me an estimate (based on the worst case scenario) i'd appreciate it. Im definitely willing to pay someone to fix it, I'm US, so if your US its better.
 





tgo111789 said:
I bought a laser awhile back on the forum.  Ran great, but I fried it.  Anywho, its a 130mW MXDL using 175ma flex.  I'd like to fix it, but I don't have the know how, or time.  If you can message me an estimate (based on the worst case scenario) i'd appreciate it.  Im definitely willing to pay someone to fix it, I'm US, so if your US its better.

Send a PM to Gooeygus

http://www.laserpointerforums.com/forums/YaBB.pl?num=1227772783/0

Peace,
dave
 
tgo111789 said:
I bought a laser awhile back on the forum.  Ran great, but I fried it.  Anywho, its a 130mW MXDL using 175ma flex.  I'd like to fix it, but I don't have the know how, or time.  If you can message me an estimate (based on the worst case scenario) i'd appreciate it.  Im definitely willing to pay someone to fix it, I'm US, so if your US its better.

it probably fried due to the simple fact that it's being pushed? assuming it was using a phr-803t diode.
it's best to run these at 120mA..you might want to have gus lower the output so it doesn't happen again.
 


Back
Top