Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

How to Register on LPF | LPF Donations

CNI Spectrometers

hwang21

hwang21

0
Joined
Mar 27, 2013
Messages
2,429
Points
63
Anyone know how good/how much CNI's spectro's cost? If it's not too high I'm sure there are a bunch of members here who want a spectrometer... me included :p any ideas anyone?
 





Yes, it is very low, I figured we may get a bit below four figures if we had a group buy.
 
I would be very surprised if their standard usb spectrometer were under 3K, not to mention their Raman Spectrometer system which I doubt would be under 6K..

You would not need a spectrometer with this sort of accuracy. Might as well get the surplus ones on ebay.
 
^^This. A good spectrometer with any of the "must have" features built-in can't be made for much less.
 
I am in need one one that can measure <0.2nm resolution.

Meatball, hopefully someone from UNL can hook me up?
 
^ Just remember you need the accuracy to back up that resolution :p
 
Money's all relative :p

Can you PM me those websites for auctions? I didn't save them in time. :(
 
Several of us were looking at these a couple years ago.

Spectrometers - Science-Surplus

They are $500, but resolution is 1nm depending on the grating.

A couple people picked them up from ebay and tried calibrating themselves for about 1/2 that. But I haven't seen any with very good results that weren't calibrated by Science-Surplus.

So far it's best bang for the buck.
 
I've talked to ARG about his, but I never pulled the trigger on buying it.

Unfortunately my predicament is determining 609.07 and 609.6.

Though I may just get it metered by a specially calibrated high performance meter at the local university.
 
bloompyle said:
I've talked to ARG about his, but I never pulled the trigger on buying it.

Unfortunately my predicament is determining 609.07 and 609.6.

Though I may just get it metered by a specially calibrated high performance meter at the local university.
Click to expand...


That's the spectrometer I had at SELEM. I need to try finding a smaller input fiber for it to increase its resolving power.

Also I changed the internal grating to allow it to cover nearly the entire visible spectrum.

If you got one (a grating) with a much higher line count you could calibrate it to a small window within the 600nm range and give you much more accurate information.

Mine was not calibrated very well since I didn't know exactly what wavelengths I was getting from my argon.
 
Differentiating between 609.07nm and 609.6nm is not a problem, it's capable of more than that :p

My grating only covers the visible spectrum, so it's pretty good in terms of resolution.
 
ARG said:
Differentiating between 609.07nm and 609.6nm is not a problem, it's capable of more than that :p

My grating only covers the visible spectrum, so it's pretty good in terms of resolution.
Click to expand...

The problem I had with mine is that the lines were so close together the peaks combined into one slightly wider hump, so although it had a peak in the 609nm region the multiple HeNe lines were not distinguishable.

This should be doable though with a high line count grating though. You lose total nm span but you could easily get down to the hundredths of a nanometer.

I ordered my grating from edmund optics, it was about $80 all said and done.
 
You must log in or register to reply here.


Back
Top