Recent content by Crosso

between the battery slip and the host?

The voltage requirement is between 3 and 5V so Im using 3 AAA batteries at 1.5V each. Its not that specific kit, but the guts are exactly the same, as is where the parts connect. The host is too short but I dont mind having the module sticking out the end. Looks decent to me plus it will be...

Its exactly the same as the one you linked to me before.

Alright, apologies for the bad blur. So this is the whole module, it's only 10mW so apparently additional heatsinking wont be necisarry, i won't be having it on for long anyway. And this is the tip of the wire protruding from the module. I can trim it shorter of course, but thats what is...

I brought the entire module, so all I have is the module (diode, lens, driver) all in one. Its sealed off, and has 2 wires running out of it. A red, and a black. Its a 532nm btw

I dont quite understand.. So i solder the positive to the contact plate thing, and run my negative to the case pin? I presume that the case pin is the little metal ring that was inside my host, holding the circuit board in place? if so, mine got bent too much to go back in.. :S

Alright no worries. So here is the button/clicky. They are the 2 plates I was talking about. One of them is in contact with the battery sleeve (see below) and I was curious how I was to connect the driver/module (all i have is a red and a black wire) to the other plate. I hope that covers it.

Hi, so my host arrived today, and it has a side clicky. After taking the light apart, the clicky is in contact with my battery pack via a a plate, and it "was" in contact with the circuitboard/LED's via the same sort of plate. My driver/module doesnt have a spring on it though, so im curious if...

Congrats to whoever wins :) I'd like to be entered too. Merry xmas everyone

I brought a 10mW red when I was in Japan and put it in my carry on luggage. Went through customs fine. The officer did ask if I had a laser with me and i blatantly said no, and it got through fine... Oops :)

yeah, thanks dude :P better to double check anyway

Not a chance that this module is coming apart lol. Its pretty solid. I've cut the cord, and I see a red and a black wire. I'm assuming now all I need to do is connect it to the batteries contact within the host?

Ive found a host that will fit it, should be here sometime this week, i got the seller to open it and measure inside it and all, it will fit pretty perfectly. It will have room for 3 AA batteries. I figured I could run it on 4.5V (3 AA's) Should be safe, yes? Im just not sure what to do with...

AH sorry about that. Didnt even realise they were that large. So your saying I wont be able to make this module porable?

Forgot images sorry