Search results

Wonderful, I was hoping this would be the case, as everything I'd come across thus far had pointed to that being the case. After getting everything setup properly, my next step will be investigating PWM control for these things, does anybody have any suggestions as to where I should start...

Re: STRANGE phenomenon I just noticed with my 405n I've noticed similar things, it seems to depend on the optical qualities of whatever you're aiming the laser at, and the level and type of the ambient light... Also, I don't think the human eye is geared toward dealing with this particular...

Hey folks, I've been busily searching this site for the past few hours, trying to gather enough of the right information to make an informed decision, and while I've found a great wealth of information, I was wondering if I could be more efficient in my gathering of it. So I elected to post...

oops, even with previewing it, I fudged that first sentence! :o It should read: "I realise that the intended purpose of the rmcybernetics pulse controller is to drive larger voltage/amperage loads at lower frequencies, however the parts values can be substituted to achieve the desired...

I realise that the intended purpose of the rmcybernetics pulse controller is to drive larger voltage/amperage loads, however the parts values can be substituted to achieve the desired frequency range. I was curious about driving LDs with it because I noticed that in the comments somebody had...

Gazoo- Thanks, I had not seen that thread. Looks like I'll just have to try it and see, good thing I don't want to mount it inside a flashlight, I don't think that I would be able to effectively shrink the PWM controller. ericab- Thank you, as well. Yes, that is the controller that I was...

Greetings all, SenKat, I have been watching this thread with fairly rabid interest over the course of the last couple of weeks and was curious as to whether or not there was still a quantity of these diodes available. Also, has anybody here tried the power pulse driver circuit over at...