Recent content by roguexx

was a joke hahah

Re: Green 150mW laser FS Ill pay 20$ lol but idk if you could get in in the US

I dont think i would feel them reviving me if, Im dead, and/or they give up lol

I didnt feel like doing it on breadboard... I was thinking about it but I decided i have never used one and this is alot easier for me lol

If you could find me a 200mw green laser for under 20$ i would give you 20$ for it :angel:

see i like the thought put into this but im pretty sure u can breathe in a vacuum... you will be breathing in nothing however but still breathing non the less

Yeah im going to wrap it in electrical tape just havent gotten to it becuase i still need to buy another battery holder

I just finished my first diode driver. I still am waiting for my 200mw 660nm laser diode but i tested it with an LED and it is working great. Just thought i would post on the forums with a picture of the finished driver... I got all of this for around 10$ ish but i already had the wire and...

its going to be on an old tiny nurf gun that i have gutted already...

It would be sweet to have 6 different lasers have a 2xblue 2xred 2xgreen have 2 of each at 200mw and 100mw lol. Design it so when the barrel rotates the one on top is on and all the others arent

I bought a 200mw 660nm red diode a few days go and i am in need of a driver for it and i am trying to go under 10$ (If possible) This is the diode Brand New 660nm 200mW Mitsubishi CW Red Laser Diode/DIY - eBay (item 250601073082 end time Jun-19-10 04:14:41 PDT) I was thinking about using this...

I was soldering together my first diode driver from scratch, i was almost done... unplugged the soldering iron and it started to slip off the table to i grabbed the correct part of the handle and moved the stand i have for it so it didnt slip again... the stand was metal... and extremely hot...

You should buy some cheapass flashlights, gut them and put the laser in it... make sure the flashlight is metal so it doesn't go through on the xray!

I got all the suplies listed in my last thread and I put everything together and it doesnt seem to work up to the Pot.... This is the pot: 100K-Ohm Linear-Taper Potentiometer - RadioShack.com there are 3 pins on it... the 1st thats connected to the regulator the middle which im unsure of, and...

So with the diode at 3v max it would be a good idea to use 7v