Recent content by pyrostic

No, I'm talking glow in the dark but in a sense glow in the dark is UV reactive material. i have Googled but to no avail.

I'm looking for glow in the dark paper, or UV reactive items like the one in the picture attached. If you know where I can get them please shoot me a link.

I need a spring to solder to the posative point on my driver... Any clue. Currently I'm trying to use a spring from the inside of a AA container. or is this going to work well enough?

what if say...there isn't a pad anymore? can i solder to where it was or is that driver junk now?

Where is a diagram on how to hook a dummy load up. i have rkcstr's in specific. i have a rkcstr microdrive I hooked the - on the test load to Gnd on the driver and hookde the posative to LD on the driver. The picture is big and blurry, but it should show how it is hooked up at least.

k cuz i just fried 2 diodes... i suppose i can wait/practice until my 3rd gets here. I have to wait for Dr. Lava to get his drivers back before I can use this host anyways...

Well I'm using a radioshack soldering iron, correct and I'm using Electrical Silver Solder (thin stuff). but my problem is it gobs up on my soldering iron and doesnt transfer to the component. I bought some flux but i'm not sure what/how it is used. If someone can enlighten me maybe thats the...

No this isn't a how to, nor do I need to know how to solder. I've just been having a little bit of trouble soldering from the diode to the board. So my question to you is: What type of solder/soldering iron do you use? Is there a way to solder and not hurt the diode (cold heat?)

so where are we going to get these labels after there gone? or anyone know what kind of printer/paper is needed to make them?

Great, one last question though. When placing batteries into my host do I want posative facing the driver or away from the driver.

I will be getting a rkcstr test load is the output the same on each of them? same directions? any adding subtracting?

As you may or may not know Dr. Lava's microFlexdrive V4 will launch in the coming week. My question to you is what do you use for a test load (links please) or do you just pay the extra few dollars for him to set it? I appriciate any knowledge gained from your replies, Pyrostic

sent payment thanks

4x <100mw 405nm 4x <50mw 405nm 8x Small Foil Blu-Ray Logo Stickers =6pounds * .04% +1pound shipping = 7.24pounds? correct?

Also does anyone know of another website to get these (i'm actually trying to find them for my professor) I called him and he would rather not have defects in his.