Recent content by pwNd

Ye, I set up a fire every night, so I can see greenie And to Dave: GET A LIFE ASAP. Think about it, you spent your life on a fuckin pn junction ffs.

omfg are you all so retarded or what??? Can you read? My driver is not fried its DDL not fexdrive and dont think im stupid or smthing. also beam should be visible w/o smoke cuz I can see 5mw green very well and this ting should be at least that visible. Also problem is not in my eyes cuz I had...

yes, Iremember that but it was months ago and I had no time to try connecting it to DDL I was busy w/ school, but now I took that laser and dissassebled it cuz I bought some 18650 batteries( before that it was ran by flexdrive and 3 aaas) cuz I thought fexdrive was f'cked up. So this time I used...

If my laser is able to burn what should be lowest mw it could be outputting? I presume if it can burn then for sure it should have visible beam? Also had LOC diode(RIP) I ran it at about 450 ma and i could see beam it was very bright, but this one not....

If you are trying to be sarcastical or somthing like that, I FOCUSED IT FFS IM NOT RETARDED. spot is small but very very bright. Maybe glass lens could cause this problem? should I try plastic ones?

Omg its running @ 330mA it should be putting out about 200mw so that would be like 20mw greenie, but it isnt, no beam at all!!! I have 5mw greenie that is maybe little OP but It has very visible beam in night sky. I have also seen videos of 16x diodes beams in night sky, so supposedly the...

Well I can make a video to show you that it burns but no beam...

I really dont understand its red I can see it very well and its bright, but no beam and nobody sees it... maybe diode is faulty, low-powered?

Ok, I have the senkat 16x lcc red diode. First it was driven by fexdrive 5 set @ 350mA. It was burning stuff well but there was no beam at all... So I thought something is wrong w/ fexdrive or my dummyload and I made one DDL driver w/ pot set at 3,8ohms what would correspond to about 330 mA...

Its then probb lower in mw i should connect diode to ddl and set ma again

But I could see the beam of my green 5mw and phr 120ma outdoors easily so i dont get how i cant see the beam of red(probb 150+mw)

Lol its not my eye nobody can see it x) i dunno but i keep it runnin on 350mA with no problem... Does anyone have 16x red with visible beam

Its 16x diode powered by 3x rechargable AAA(900 mah) and lava flex drive v5. I used homemade dummyload of 4x1N4007 and 1 ohm resistor to measure 350 mA...

Yes, it can burn easily, much better than my phr@120mA, but maybe I should increase the mA? What is highest safe mA for a 16x diode? And, Stuart can you see the beam from all angles? Like some 10 mW green? Ty all

Is that normal that I cannot see(even in dark) the beam of LCC that is running at 350mA? If not, then should I run it on higher mA or what?