Recent content by MrLWJPDX

Will do on monday when i get back in the shop. Thanks.

Yes, using Dummy load. Built to spec found on forum for dummy red or blue dummy load. Any ideas?

Amen.:angel:

pyrotech, Nope sent an Email to the Dr. Himself back on 11/23. So far no answer, I am assuming other things are keeping him hopping during the holidays. Hope get an answer eventually,:whistle: I have all this cool stuff and no way to play with it yet.:cryyy: Don't want to buy another driver...

Thanks Silvershot. It is an autorange DMM so that is why i am wondering why I get a 12mA reading.

Info from Scopeguy was I should set it at about 140-150 mA. For a tested GGW diode. And yes there is a bridge between two right hand resistors. What I do not understand is the reading with the dummy load astride the resistor of 12.00 mA Or am I moron and reading it wrong and it really means...

I finaly got around to building a dummy load for testing. Hooked everything up using 6 diodes in this instance for a BluRay. Checked everything about 4 times, put power to it. I got a voltage reading on the output of 4.7 volts, but a mA reading of 12.00 It is a Flex Drive V4 that was set for 215...

Tom, poor choice of words on my part. My Appologies if I offended. I just figured it was dead and I wanted to get some units for myself, this seemed a good way to do that and get a decent price for others at the same time. All the best. Larry

well folks looks like no one is interested. Hope I did not offend anyone by making the offer. Happy Holidays everyone. Go forth and Lase.....

Ok boys n' girls. I am new here I have no rep and few posts, but I wanted some from the aborted GB of these that went south. Before Dave or anyone else gets all excited, read on. Like the cheap SOB I am I decided to simply buy direct from Dorcy, an advantage of having your own company, you can...

Re: Flashlight gb - dorcy cr123 - CHANGES MADE I will take 2.