Recent content by Morgantao

Well... That's what people said in the comments of a video I've seen... I guess it's true what they say, you can't believe everything on the internet :p Apparently I used to be a lot stronger or smarter 3 years ago... I can't seem to get the damn laser pointer open! I swear it was...

I think I'll have to dissect the green laser pointer again.... I know that some of the IR passes through with the green, as I've seen green lasers that cut black duct tape, where it was actually the IR bleeding out that was heating and burning the duct tape. I also know what an IR filter looks...

Ah, OK. First of all, no offense taken. I'll be the first to admit I only know the very basics of lasers and electronics. Besides, English is not my primary language, so even if I knew the right terms of everything in my first post, some might have been lost in translation. I know the laser...

First of all, I'm not going to use the IR laser until I have my safety goggles. I kinda like the ability to see. In any case, the laser is contained inside a closed black box, as it was when it lived in the printer. I'm sorry if I'm not familiar with the terms and the jargon of the laser...

Hi everybody! I have a Class 3b IR LED from a laser printer. I was wondering... Can I take the dye from a cheapo class IIIa green laser pointer (<20 mW) and put it between the LED and it's lens assembly? And would this give me a higher power green laser? Thanks!