Recent content by MoeSizzlac

Gap is all over about .5mm and some spots a little less. It fits pretty snug but will no where be efficient enough to disperse heat like a press fit system. That is my trade off. As for the Beam Expander - Yes, I would configure it to fit inside a space roughly 18.5mm wide by 23mm deep. If I...

3D Printed is ABS. I like it better than PLA right now. Press used - It is not pressed in as I need to be able to slide it in and out for battery changing. Is that wrong? I don't know because this is my first laser build. I have a little less than .5mm clearance in the chamber and I was...

Hello All, I've been lurking around gaining some knowledge but I have much more to learn and I'm looking for anyone's help that is willing to give it. I built a 1 watt 520 nm DTR laser 25mm copper module with driver and G2 glass lens into one of my favorite hosts I could get my hands on. See...