Recent content by macpod

If it's anything like the ttl version, you will need a 12v power supply to power everything You will see there are red,green, and blue headers on the board. These control the respective lasers. -Leaving the wires disconnected = lasers are on full brightness -Pulling the outputs up to 5v =...

It amazes me that the colors stay together that well for you. Mine separate noticeably after 7ft. There is lots of red glue in these units, but they appear to have tapped aluminum blocks and lenses screwed into them so if you can get that off, you should be able to use a large flathead...

The analog ones generally go for 3$ more than their ttl counterparts... I directly asked and they assured it was analog. Still hoping someone has one that could take some shots.

I have the TTL version of this. For the diodes and driver (and internal fan), I felt it was a good deal. The optics could be better adjusted.. it's posible to do yourself, but you need to clear out lots of red glue. Hopping on ebay recently I see some sellers are advertising these exact same...