Recent content by Laser_Spyro

I’ll see what I can do, thanks. But just to let you know, I can’t post links yet since I don’t have enough posts, so it may be a while.

Sorry for not getting back to you quickly, been busy. I’ll try to get a better quality shot, but this website only allows a pitifully small size attachment to be added to a post. IPhone photos are high quality and consequently huge in file size (even when cropped!), which this website does not...

I’m in the USA, Alabama in fact. I will send it to you, DM me and we can exchange necessary details to do so. Thanks lad! :)

That is correct, the “C” and “D” terminals. As for all of your input on the delay, I turned the power on, and nothing. No flicker, nothing, nada. I might try shorting those terminals on the connector and see what it does. Unless, that is, someone knows how to operate this board and can tell me...

Okay, thanks! Just for reference, are these one shot or do they take a minute to warm up? I’ve only ever used LED lasers, so I’m used to one-shot activation.

The tube is actually soldered in. Also, I found two marked pins on a connector (for inputs most likely) that look like they go to a switch or button that would activate the tube driver circuit via signal side

So this is line powered, right? Just want to make sure I don’t plug it in only to get a bright, loud *bang* and shards of projectiles in my body.

Is this better? I can’t upload anything bigger because the site limits the file sizes far too much, and I’m forced to make the image smaller.

It’s difficult to track someone solely based on their face. With a name though, you could look up a whole lot of personal information about someone. Thanks for the welcome though! :)

Hello, I sorta wish to keep my actual name anonymous due to some privacy attacks I have experienced before, so my apologies if that is inconvenient. Anyways, I’ve been huge into lasers ever since I was 16. I’m 18 years old now, I’ve been studying safety of laser operations and the basics for...

Okay, I’ll go ahead and do that. Thanks mate.

Hi, I’m new to gas discharge lasers and found a few old boards in my community college. I was granted permission to see what I can do with them, and I am hoping to get them in working order using the original drivers. However, I have never seen this driver board before, and I saw a post made by...