Recent content by HACKALASERS

you know ill just pay for those instead of some cheap goggles i would rather not be blind. 8-)

Re: Yet another DIY laser. With a question mixed i ok if you are planning to youse a 20x laser diode then i would put it to 400ma but at first i would have it at 350ma to see how it works and remember to youse saftey goggles if you dont you will blind your self even if it does not hit your...

so these will protect me from a 300mw laser from a 20x dvd burner?

wich one is cheapest and is good for my eyes and also will the one that protect blue ray and red be fine for 300mw red 8-)

ok i have a 300mw 660nm it cane from a 20x dvd burner i need to know wich googls i shuld get. :)

I WAS JUST ABOUT TO PAY UNTILL I READ YOUR COMMENT.

very nice im working on a 300mw red. :)

nice im just finishing up my 300mw laser ;D

well if it is going to but out 5v as a output to yor diode then your laser could blow out i may be rong becouse i only used that 7805ct ones. i would just use the lm317t and use a 10ohm resistor,capaciter 35v 47uf, and a diode for reverse plioredy (may be spelt rong) and that should give you...

Re: FS: "Long Die Open Can" Diodes how do i order you gave me a invoce? :-/

hey do you know were to get some good goggles for these. :-/

thanks for the info. and i already know all about the drivers it is just that my volt meter was down. ;D

ok i have a 300mw red laser 660nm am i damaging my eyes from this and also i have never turned it on before becouse i am waiting to get enough $ to buy some goggles.

hey do you know how to order a diode from the monk?

Re: FS: "Long Die Open Can" Diodes how do you buy this :-/