Recent content by floridahigh

i have hooked up a recharg batt to my diode and it burns like crazy has been for probably few weeks now is there a safe voltage, is this safe for diode life, and what would be the correct voltage to run at max? the reason i ask is because i have a few of the flexdrives but they seem to not be...

alright so heres what i got after breaking the pin flush with the top of the diode and trying to solder on top of diode to new pin i found that dressing a wire with solder and then gently setting ontop of orig broke pin in diode and the covering with jb weld was better than just trying to solder...

well i have no source for measuring anything except shining on arm, now when it was high it seemed to burn some but when pot fell off it is not as bright with glasses and i cant feel any heat??? i imagine i was pressing to harrd with screw on the one drive but the other i have it just fell of...

so i finally get this  badass laser goin and as im adjusting the pot the top of the pot comes apart from the board, it looks like a little disk, so my question is can i just solder over the top of the pot at def low and get 115ma or would it be better to jump to high and me assume that it would...