Recent content by Diesel

I often wondering what are the reasons to make it so HUGE for those small power lasers? Aren't they really PORTABLE?

Thanks for the information. I've tried to set my DPSS 532nm 200mW become extremely small Green spot, and so, i believed that it must be below 1mW. Well, this is what i experienced from my 200mW laser, however, i cannot guarantee another cases, it might just be an individual case that i thought...

800mW is available :O Besides, there are 2 focusable (200mW Max) choices too.

It's possible to set the power lower than 1mW from a 200mW laser module driver. i'm not sure they allow you import this or not, this is just my idea.

Definitely FAKE! Where's the smoke? He was "Cut" the tape by applying force.

um...nope, it's true, 15feet takes 1seconds, but after 20feet, would takes much longer time, i think the reason is - very difficult to focus, the laser line is likely becomes parallel at 20+. (i tried to focus for at least 20min, the nut is very sensitive when the line nearing parallel...

Good work Igor! It does not matter and is understandable that something very important you need to handle first before, finally solved, and luckly I can still be your customer! Firstly, Just try to focus well, and be patient, i believed that the difference between my 218mW super-freaking...

Folks, I have just received my second IgorT laser on 28th August. The laser I ordered is 6x-405nm@215mW with a Higher Wavelength Freak-diode. Let’s have a look at the package (for some reason, address has been hidden.) Opening the package, the contents seems very safelly packaged. As you can...

Re: CNI GB starting Updated PGL-III-A-532 150mW /Unit USD300.00 PGL-III-532 150mW /Unit USD260.00 Why is the bigger one(PGL-III-532) cheaper than the smaller one(PGL-III-A-532)? It's same mW.

Re: FS: >110mW PHR, >140mW 4x & >170mW 6x Blu-Rays Oh?  Could you? Kill diodes, make heatsinks, driver circuit, development, fine tune, improvement? You CANNOT just calculate the cost of RAW-MATERIAL! eh...... :'( Is it mine?   :D

Do you mean SXD?

In pic 3 there is 2 heatsinks.If you use the original heat sink of the host then what is the other one is for? The rest of that part (the front) is an aluminium ring only. in pic 4 what is that thing at the end of the LD driver? it's an LED reflector (plastic). CR2/CR123A is enough for this...

exacly......I tested at least 40 green modules which are produced in China, 3mins for each one, because i don't trust their quality and then I’ve got 23 modules…..fail!

Hong Kong...... You may also take the module out from this kinda laser. http://www.dealextreme.com/details.dx/sku.11047

4......