Hi,
I removed a 405nm diode from a damage unit mean for UV curing station as shown below.
Yes the unit is damage and not sure what is damage and I was hoping is the power supply since it cannot power up the diode for curing.
The picture attached is the laser diode chip mount on a round heat...
Payment sent for 5 drivers set to 1.25A. Thanks.
The driver board does show LD+ & LD- pins but I do not see the Batt+ & Batt- pins.
Is that right?
Batt+ ----------- LD+
Batt- ----------- LD-
thanks for the quick reply.
i manage to add a diode (1N4148) across the LD+/-.
Jib's driver require a min. of 6V to work but with 1 CR123 the diode can still power and lit-up but not as bright with 2 CR123 in series.
Sorry to hi-jack the thread.
i do have a 1.25A jib driver and as known there isn't any diode to prevent battery reverse polarity. i am wondering if it is ok to add a diode across the LD+ & LD-?
I actually order x4 1.25A jib drivers but end up receiving only 1 pc.
I am sure there is a mix up and Matthew did refund for the x3 drivers I did not received.
Matthew is doing a us a favor and I certainly hope that the person who receive the extra drivers return or pay Matthew the balance.
hi guy,
brought some 1W 808nm LD from eBay.
now hunting for drivers to drive it.
having read all possible threads available in particular the thread by Ron using AMC7135 back in 2008 but inconclusive.
please help me out is the connection as below correct:
since the diode is 1W TO-5 type i...
after my purchase of 4 drivers you drop the price by $2 and now with each driver purchased in the next 24 hours of this post get a free focus adapter.
guess i made my purchase too early :(
patience is the name of the game :( sob sob sob.....